Tractor Talk Discussion Board |
Re: O/T Seeking GM transmission advice
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brokenwrench on July 28, 2005 at 14:07:08 from (69.128.199.115):
In Reply to: O/T Seeking GM transmission advice posted by MeAnthony on July 28, 2005 at 12:29:49:
When driving from a stop up to highway speed you should feel a 1-2 shift,2-3 shift, 3-4 shift and lockup. The lockup can come on in 3rd or 4th depending on the load on the vehicle. A quick way to test the lockup system is to get up to 55, and while holding steady on the gas, slightly press the brake pedal. you should see the tack jump alittle, or here a slight RPM change. When you let off the brake, the RPM should drop back down slightly. I doubt your harsh engagement, is related to the converter. As stated before, if the converter were locked up you"d kill the motor. Your harsh engagement could be something simple like your new motor idling faster. Especially on a GM, where the trannys engage quick to begin with, idle speed can make a big difference. You could also have driveline slop, (ujoint, transfer case chain, differential). If this engagement problem showed up after the motor swap, I"d chase the idle. Good Luck Brokenwrench Just a thought, as Allen said (I think), The 700 doesn"t run a vaccuum modulator, so this thing lives and dies by the throttle valve cable. If that thing got way misadjusted or the cable got frayed it could be hanging the throttle valve open, that could make for harder engagements as well. but for that to be true you"d have high hard upshifts as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|