|
Tractor Talk Discussion Board |
Re: Why narrow front tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian in NY on July 28, 2005 at 08:35:21 from (66.14.199.4):
In Reply to: Re: Why narrow front tractors posted by Vince H on July 28, 2005 at 08:18:02:
Vince, I can see why you are confused, and I can understand why your gut is telling you different. The truth of the matter is that it is not that a narrow front is a model for stability. It is just that people get a false sense of security with a wide front. Because of the way the front axle pivots on a wide front, your pivot point is effectively much the same as a narrow front. So even there are "stops" on the wide front, by the time you hit the "stops", the tractor is already on it's way over.
The only absolute way to avoid a rollover is to avoid side hills, and avoid raising the center of gravity on the tractor while on any side hill (raised loader with a load, etc). Hope this isn't too confusing, but the main thing to remember is that all tractors are quite suceptible to roll over, no matter what their configuration, due to relatively high center of gravity.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
