|
Tractor Talk Discussion Board |
Re: Air Conditioning Problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on July 21, 2005 at 23:28:21 from (64.21.249.40):
In Reply to: Air Conditioning Problem posted by Willy P on July 21, 2005 at 19:29:29:
My first suspect would be a bad compressor shaft seal. Refrigerant and oil circulate through the whole system. When the unit is used every day, the compressor shaft seal and any tiny leaks at "O" rings and crimped hose fittings have a coating of oil on them, which tends to slow down the leak. When they sit unused, these areas will tend to leak more. Almost always, there will be an oily deposit, with dirt stuck to it, if it is a fitting or line leak. A bad compressor seal will throw oil out ahead of the belt pulley, though the plate on the magnetic clutch. On the "40" series, there are hydraulic oil cooler hoses that dangle ahead of the AC condensor, and sometimes wear though the condensor and create at tiny leak (at first). I don't know if that is a possibility on a "50" series. The refrigerant lines from the cab top drop down through the rear LH cab corner. They are insulated, which traps moisture and dirt, and they sometimes get pinholes rusted in them. Beg, borrow, buy or steal a refrigerant leak detector. Allow the tractor to sit a half-day. or so, inside, out of the wind. Then, check for leaks at the compressor clutch, all fittings, and at the bottom of the cab corner, where the lines exit. Refrigerant is heavier than air, and tends to fall, so check UNDER areas that may have a leak. When you've checked out everything else, put the sniffer tip next to the air vents in the cab top. If there is a leak up in the evaporator box up on top, the sniffer should detect refrigerant dropping out the vents. You can turn the fans on "LOW", and click the key on for a second, to blow a shot of air out the vents, and see if the detector picks up anything! Good Luck, likely, your gonna need it!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|