Tractor Talk Discussion Board |
Re: Standard or overbore engine kit-- which to use
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike M on July 21, 2005 at 18:48:19 from (63.27.171.160):
In Reply to: Standard or overbore engine kit-- which to use posted by Darren in TN on July 21, 2005 at 06:46:43:
I think some of those dry sleeve over bore kits may leave the sleeves out and run in the block.I'd check it out closer. I wouldn't want this as I'd rather be wearing out a replaceable sleeve. But if the overbore kit still used sleeves but offered more power I'd go for it. Never heard many complaints of too much power. Your tractor should have a water pump so it should cool ok. I was advised once not to put the soup up kit in a Farmall C that didn't have the water pump as it would over heat.I took this advice.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|