Tractor Talk Discussion Board |
Re: Dismounting old tractor tires
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by flathead on July 21, 2005 at 05:59:10 from (170.143.252.32):
In Reply to: Dismounting old tractor tires posted by Mike from cny on July 20, 2005 at 21:48:41:
I tried breaking beads on my old 8N tires by driving my truck up on a board on the tire sitting flat on the drive; didn"t work. Tried sledge hammer and pry bars; that didn"t work either. I took them to the local coop and they wanted $70 each to get my old rotted tires off; told them no thanks. Finally cut the tires off using a sawzall for the rubber and an angle grinder with a cutoff wheel for the steel wire reinforced tire bead; That worked fine. flathead
Follow Ups:
Home
| Forums
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|