|
Tractor Talk Discussion Board |
Re: Is square baleing seriously that hard?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thurlow on June 20, 2005 at 09:31:18 from (65.255.98.37):
In Reply to: Is square baleing seriously that hard? posted by Stephi on June 19, 2005 at 14:06:52:
Sure, you can "run" a square baler; anyone with a little technical/left-brained knowledge can do it. Is the boyfriend's Dad a "real" farmer or someone playing around with a few acres? Things have changed in the last 30 or 40 years, not necessarily for the best. Farmers have become VERY conscious of the liability they can incur when allowing people onto their property and/or dealing with farm equipment. Boyfriend sounds like a piece of work/classic chauvinist. Bet you can do better. Doubt that either he or his Dad could have worked for me; the radio disqualifies them; anyone with any serious time on a piece of harvesting equipment (at least before the advent of electronics/shaft monitors, etc) depends on the sound, vibration, and a seat-of-the-pants "sense" of what's happening in additon to the visual clues. When he (boyfriend) picks you up on Saturday night, does he come inside and talk to your folks while you finish getting ready or does he sit in the driveway and blow the horn? Maybe I'm the chauvinist......sometimes I think I've outlived my "time". Read this yesterday.........if someone from another planet came and was asked to listen to our music; rap (I know, the term rap music is an oxymoron), hard rock, rock and roll, do-wop, jazz, blues, swing, and the music of Porter, Gershwin, etc and then asked to put it into chronological order, they would surely get it EXACTLY BACKWARDS.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|