Tractor Talk Discussion Board |
Re: Is square baleing seriously that hard?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Can't even use my name on June 19, 2005 at 19:23:43 from (216.241.134.34):
In Reply to: Is square baleing seriously that hard? posted by Stephi on June 19, 2005 at 14:06:52:
Where were you about 3 years ago when I was 22 and single!? Anyways, no driving a baler or even a combine is any kind of difficult task... but running one correctly is an art. But baling especially if you are just dropping them on the ground is rather easy to learn if you have any common sense, a bit of tractor knowledge, and a ear that can tell when something has changed. If I were you I would kick that BF right in the shin next time he acts that way then do it once for me! We have a thrower on our baler that you can change its direction and distance using that hydraulics and a control box so it is a bit more complicated but none the less if you wanted to come try it out I can give ya directions, gas money, and probably lunch.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|