|
Tractor Talk Discussion Board |
Re: Did I blow my engine?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Bloggs on June 12, 2005 at 08:48:46 from (209.247.222.42):
In Reply to: Did I blow my engine? posted by d-deral on June 12, 2005 at 04:34:58:
2 coments. first how full is your oil because if it was over full and you had it on an angle there is a chance the crank case breather pipe that goes to the inlet manifold could have started sucking oil instead of vapor. the next thing is if the oil return (no preasure) from the head to the oul pan is restricted you get an oil pool in the valve cover then you can loose oil out the breather cap and quite alot . I have seen on an older jap car with a sideways engine the hole at one end of the head was completly blockes and every time the owner would drive along the creek crossing it would blow white smoke. he was told by a mechanic he needed a new engine. it was fixed with a screwdriver by opening up the drain/return hole in the head. thats my 2 coments.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|