|
Tractor Talk Discussion Board |
Re: My first treasure
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RWK in WI on June 07, 2005 at 17:49:54 from (169.207.95.47):
In Reply to: My first treasure posted by Errin OH on June 07, 2005 at 09:49:09:
Not while plowing, but a few years ago I went to cut down a oak tree near a shed. I know it was hollow so I put a rope on it to pull it away from the shed. Got the notch cut and started the falling cut. Just got into the hollow part and the saw went dull. Stopped and shapened and tried again. Dull immediately. Did side cuts and chopped. Finally got the tree down and there was a old rifle barrel. It was about 100 years old according to the historical society. Likely some settler, trapper, or lumber jack hid a gun in the hollow tree and for some reason never came back to get it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|