Tractor Talk Discussion Board |
Re: Ammeter
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Lee Bradley on May 16, 1999 at 10:03:08:
In Reply to: Ammeter posted by Tom on May 15, 1999 at 22:20:20:
Tom, The old meter was an inductive meter, that is it measured the current flowing through the wire clamped to it. Cut that wire in two and put terminals on the ends and connect them to the new meter. Be sure and pull all the slack out of the wire through the meter hole then cut the middle of the loop. This will give you the most lenght of wire to work with because 'Murphy' will require the wires be connected to the post furthest away. Or get an original meter. Good Luck, Lee
Follow Ups:
Post a Followup
|