|
Tractor Talk Discussion Board |
Re: Marvel Carburetors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on June 04, 2005 at 20:20:02 from (64.42.242.8):
In Reply to: Marvel Carburetors posted by J. Schwiebert on June 04, 2005 at 18:34:28:
Right here on the YT site in the left menu under "articles" there is an excellent article on rebuilding an MS cast-body carb. I think it is for an N-series Ford but all of them are pretty much the same. The only criticism I'd have of the article is the author's references to removal of brass parts like jets, fuel nozzle, needle seat, etc. He talks as if they just come out easy and they don't. You must heat the carb body (after disassembly of course) with a propane torch or perhaps heat it up in your barbeque to a nice hot temperature. The brass should come out but still be careful, once those things twist off you're left with a paper weight. And make sure that whatever you are using to remove the brass is a GOOD FIT on the brass (eg. screwdriver, wrench, etc). The heating is for cast iron carb castings, not pot metal ones.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
