Re: Rebuilding a hydrostatic trans.

Posted by Gene Davis (Ga.) on May 27, 2005 at 19:16:02 from (66.82.9.55):

In Reply to: Rebuilding a hydrostatic trans. posted by Hurst on May 27, 2005 at 15:44:12:

This is a job that requires a super clean enviroment, special tools and gauges for measuring tolerances, torque wrenches,and a good set of specfications to measure and check tolerances of each wear prone part against the factory specifications. There is a lot to be said also for being familiar with the job. It is also nice that they can put it on a test stand and be sure that it performs correctly before being installed in the tractor. It can be done by a good mechanic, but I personally think that it is better when done by the experts and then warranted by them.

Follow Ups:

• Re: Rebuilding a hydrostatic trans. Hurst 08:14:28 05/28/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]