Tractor Talk Discussion Board |
Re: stuck clutch on IH 474
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike (WA) on May 25, 2005 at 08:30:29 from (209.213.153.111):
In Reply to: stuck clutch on IH 474 posted by wrenchinMI on May 25, 2005 at 06:27:47:
You can usually get at the clutch by removing the starter and working through the hole. Heat a kitchen knife about 2 inches from the end, and bend it 90 degrees. Tie the clutch pedal down, and, working in the gaps in the pressure plate, work the point of the knive down between the clutch disk and flywheel. Because the tool is bent 90 degrees, you can pry on the disk by moving the knife handle laterally. Rotate the flywheel, and repeat. You'll eventually "worry" the disk loose. Might want to tie down the clutch pedal in the future during wet seasons, because it seems some tractors are prone to stuck clutches, and will do so over and over.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|