Tractor Talk Discussion Board |
Re: Traction Problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on May 18, 2005 at 14:08:10 from (66.60.197.201):
In Reply to: Re: Traction Problems posted by TimWafer on May 17, 2005 at 17:58:07:
Those tires look good & should do, tho the long/short bars are not quite as good as standard tractor tires with a better pitch it turns out - aftter all the advertizing dust settled & real world experience kicked in. :) But, tires look fine, no problems there. Lower air pressure will help. Less weight on the front, a bit more on the rear will help for the disk. Duals will help in wet condion, but frankly in dry ground will decreace lbs per inch & not add a whole lot. A 3pt plow should be adding wieght to the rear wheels, should have no problems there...... If you had a trailer plow on wheels, then it helps to angle the hitch from the plow up to the tractor drawbar - transfers weight from the plow to the rear wheels. Your 3pt plow should naturally be doing this. How deep are you going with the plow? A 14" plow should be going about 7 inches deep. Has this ground been worked lately, is there a plow-pan you are catching. Was it used for a parking lot? My sis bough a place with a 4 acre bean field, could hardly work it up for her after the auction the previous owners had and all the pickups were in for a parking lot.... What size disk blades are on the disk? Some light duty disks are around 14 - 16 inch blades & a tractor hardly notices the thing, while some are breaking disks & have 22 - 24 inch blades heavt frames & weight added and a 150 hp tractor can be loaded with a 10 foot disk.... Difficult soil conditions can be a problem. Very, very, very dry ground can make my tractor stand up on it's hind legs when plowing, & I have a bigger setup with more weight all around. Traction in loose ground with a disk can be 'interesting' depending on a whole lot of conditions - moisture, disk blade size, soil type.... --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|