|
Tractor Talk Discussion Board |
Amazing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RustyFarmall on May 18, 2005 at 13:27:29 from (207.32.13.201):
I was using my angle grinder, equipped with a cup brush to remove paint and rust from a pto shield for my M. The brush caught on the edge of the shield and immediately removed itself from my hands. Out of the corner of an eye I saw the grinder go air born, about as high as the cord would let it. It came back down, zoomed across the work bench sort of like a drag racer, and then landed on the floor, still running. I picked it up, and continued on, thinking about how lucky I was. The wire brush had managed to dance across my knuckles, but barely even broke the skin. It was a genuine Kodak moment, but no one was there to capture it, and I refuse to repeat it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
