|
Tractor Talk Discussion Board |
Diesel timing light adaptor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jdemaris on April 29, 2005 at 05:37:17 from (209.23.30.175):
I want to build, or buy a reasonably priced pulse adaptor so I can use a conventional timing light on diesel engines with mechanical injection. So far, the one I've seen for sale is made by Ferret and sells anywhere from $200 to over $300 is you buy it under the Snap-on or OTC name. Also, when you buy it, it is specific to the precise OD of the injector line, and extra adaptors for different sizes are close to $100 each. I suspect, as is the case with most specialty tools, this thing cost about $20 to make. So, has anybody ever made their own or found a cheaper units around? I found the following suggestion for building one, but it doesn't sound like it is actually for mechanical injection: "Make a 100 turn loop of #26 magnet wire that is large enough in diameter to put around the injector solenoid (loose loop). Wrap tape around to hold the loops together. Drive the base-emitter on a 2N3055 transistor with the loop outputs. Connect your strobe trigger connection across the collector-emitter on the transistor. You might want to add a 1k, 1/4 watt potentiometer in series on the transistor base and start with it at 1k, adjusting down until it's just enough to trigger the transistor. The 2N3055 is pretty cheap and it has pretty high gain. This means it will use very little induction current from the injector to trigger it."
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|