|
Tractor Talk Discussion Board |
Re: Know when to let it go
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NEsota on April 26, 2005 at 21:54:29 from (4.159.162.172):
In Reply to: Know when to let it go posted by Bryan in Iowa on April 26, 2005 at 11:29:48:
What I think I see in this discussion is that the potential buyer is being disappointed with the other person�s decision. When dealing, especially with individuals, people often try to buy for less than the actual value and then are disappointed when there is no deal. Or they try to sell at a price that is above actual value. Here is the way to not be disappointed. When buying,put your offer at a level high enough that you do not really care if it is accepted. When selling price at a level low enough that you do not care if it sells. If you make a deal, both parties should be happy if you do not, same thing. It�s so simple.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|