|
Tractor Talk Discussion Board |
Re: OT More truck/trailer questions ( kinda long)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on April 26, 2005 at 02:35:29 from (4.240.42.82):
In Reply to: OT More truck/trailer questions ( kinda long) posted by George in Biloxi on April 25, 2005 at 10:59:03:
Hi George, About the only thing I can add, is I would consider using a 2-1/2" or 3" receiver tube with a 1" or 1-1/4" pin. I use 2-1/2" custom built receiver with a 3/4" pin and I noticed with my tri-axle flatbed pintel, my pin shows some offset wear after about a years use, maybe 2k miles total OTR use. That's about as close to pin shear as I want to come. I'll be changing to a 1" pin shortly and I use tractor top link pins as they have a nice hole for a pad lock. I used a 40ton pintel hitch off a semi trailer along with a solid 2-1/2" steel draw bar then made 20" of total adjustment in the ball mount plate, 10" up/down, with a 1/2" x 2" plate gusset. I then use two 5/8" grade 5 bolts to attach either the ball mount head or the pintel head. When I change the pin too 1", I'll also add 1/4" thick flat washers to either side of the pin hole. This will give me 1/2" total thickness on either side for the receiver pin bearing point. My 3/4" pin wear could be coming from to thinn of bearing point sidewall and not from being overloaded (pin size overload). T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
