|
Tractor Talk Discussion Board |
electric clutch adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carey Knight on April 24, 2005 at 09:14:48 from (69.172.30.92):
In Reply to: Need a greasy expert posted by williamf on April 24, 2005 at 03:49:01:
I need to set the gap and change the belt on my 1215 cub cadet. To change the belt I need to take the electric clutch off. Is there a holding place to stop the staft from turning to get the clutch off. Every time I turn the bolt, oif course the whole shaft turns. Any hints? Where do I set the gap for the electric clutch - I don't have a schematic to see where the magnet is at -any schematics available anywhere?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
