|
Tractor Talk Discussion Board |
986 I.H. opinion needed
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by M Nut on April 20, 2005 at 11:28:15 from (64.8.188.133):
A few weeks ago, I posted a question about a 986 with no 3pt. Well, I went and looked at the tractor and the headgasket was leaking a slow seep. The dealer then took the head off, and discovered that the engine needed a complete rebuild. They also decided it needed a clutch and are replacing it at the same time. Yesterday I found out they found that the TA is also very poor, and they are going to replace it. So now the tractor has a new engine including sleeves, pistons, bearings, etc. as well as a new clutch and now a TA. The tractor has very nice metal, they replaced any bad glass in the cab, and will paint the tractor as well. (They do a nice job painting. If seen other tracors they have done.)I can buy this tractor with all work done, new paint, working AC and heat, 50% rubber for $9000.00 What do you guys think of that for a price? Thanks for any opinions.
P.S. 3pt is not needed as I already have 4 decent sized tractors with 3pts. This will be used 90%+ for pulling a round baler and a haybine.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
