Tractor Talk Discussion Board |
Re: stearing wheel removel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NC Wayne on April 15, 2005 at 18:34:21 from (205.188.117.74):
In Reply to: stearing wheel removel posted by bplotts on April 15, 2005 at 04:20:13:
Try soaking it overnight with PB Blaster or some other good penetrant. Put the nut back on it and thread it down til it almost touches. Now set in the seat or get yourself where you can put both knees under the wheel and lift up on it as hard as you can and at there same time either you or somebody else hit the shaft with a hammer and brass punch. The nut will protect the threads as well as keep the wheel from jumping off and throwing you off the seat. Had man wrote in a year or wo back that had tried pullers, etc with no success. He tried it this way and said the wheel jumped right off. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|