Tractor Talk Discussion Board |
Re: LEAK ON ENGINE BLOCK ON MY 9N FORD TRACTOR
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pitch on March 30, 2005 at 15:55:50 from (66.218.28.230):
In Reply to: LEAK ON ENGINE BLOCK ON MY 9N FORD TRACTOR posted by JAMES BRINKMAN on March 30, 2005 at 13:33:04:
Thats the most common place for those to crack from lack of antifreeze. There is not a lot of pressure there so it does not need wellded. Wire brush the whole area to bare cast so you can see the extant of the crack. You probably want to drill a small hole at the end of the crack to keep it from running any further and the using an angle grinder carefully and gently v out the length of the crack. clean the area completely and apply JB Weld. You can even press a coarse sandpaper into the weld to simulate the casting grain, paint your favorite color and your done.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|