|
Tractor Talk Discussion Board |
Re: when to cut hay...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom in TN on March 27, 2005 at 08:02:45 from (205.188.117.7):
In Reply to: when to cut hay... posted by Tim Shultz on March 27, 2005 at 07:36:54:
Tim, I read in a farm magazine a few years ago that the sugar content of grass is higher in the afternoon than it is in the morning. They were sort of recommending cutting hay in the afternoon. However, in practice, everyone I know cuts when they can. We have short dry periods here in Middle Tennessee in the spring, so most of the guys around here try to cut in the morning to take advantage of that day's drying time. It normally takes two or three full days of drying at 80 degrees heat, then we rake and bale. It is sometimes tricky to find four dry days in a row. I have been trying to find a hay tedder that I can afford to buy to try to help shorten the drying time, but so far, my money hasn't matched the available tedders. So, the short of it is, I think you should cut when you can. Good luck, Tom in TN
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|