Tractor Talk Discussion Board |
Re: Want to build a polebarn, where to start?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FRANK on March 19, 2005 at 17:42:02 from (209.240.205.61):
In Reply to: Want to build a polebarn, where to start? posted by Mike from cny on March 19, 2005 at 17:23:00:
I WAS GOING TO BUILD A 30 X 40 BUT WENT WITH A 30 X 50 AND NOW WISH I HAD WENT WITH ABOUT 40 X 60. SEEMS NO MATTER HOW BIG YOU BUILD, IT,S NEVER ENOUGH. FIRST OF ALL YOU WILL NEED A SLAB AND A 30 X 40 WILL PROBABLY TAKE ABOUT TWO GRAND OR BETTER.IF YOU EVEN THINK YOU WILL NEED MORE ROOM, I WOULD SUGGEST POURING THE BIGGER SLAB FIRST. IT WILL BE CHEAPER IN THE LONG RUN.IF YOU USE WOOD POST, (4X6) AND KEEP YOUR WALLS AT AROUND TEN FEET, THEN USE CORRAGATED SHEETS AS OPPOSED TO THE 26 GA. METAL, YOU MIGHT GET BY FOR THE TEN GRAND, BUT IT WILL BE CLOSE.HOPE THIS HELPS, GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|