|
Tractor Talk Discussion Board |
Re: Wiring two battires to get 24 volts from them
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on March 13, 2005 at 05:44:15 from (4.240.42.142):
In Reply to: Re: Wiring two battires to get 24 volts from them posted by HarryG on March 13, 2005 at 05:25:21:
Hi Harry, On my 36v golf cart I can charge two battery's with a 12v charger without disconnecting cables. I have to move the charger 3 times total to get a complete charge. This is the slowest charge configuration. About 48hrs recharge time. If I seperate the 6 battery's in groups of two for 12v, then I get a faster recharge time than not seperating them. Again moving the charger 3 times. About 10hrs recharge time per-set. I series three 12v chargers so I can charge all battery's at the same time. This gives me 40vdc@6amps. 6amps is my smallest charger. This method recharges all six battery's in about 8-10hrs. You could also series two 12v chargers for a 24v system. T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|