|
Tractor Talk Discussion Board |
Re: Is running a dozer hard to learn?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john in la on March 07, 2005 at 18:04:40 from (65.6.127.206):
In Reply to: Is running a dozer hard to learn? posted by Thomas2 on March 07, 2005 at 09:09:54:
Running a dozer is a piece of cake as long as all you want to do is ride around. Most can even spread out piles of dirt with a very few hours of practice. BUT................................... I have been around all types of equipment from skid steer loaders to 1000 ton cranes and can tell you no one can answer this question for you. Operating a piece of equipment can be taught but you are usually born with the knack. I have seen a 12 year old boy that could blue top with the best of them but then again I have seen some so called operators that could practice till they are 120 and still not be able to blue top. So lets look at the real cost............ Others have stated that a experienced operator would take 20 hours to do the job. You can expect to double that or 40 hrs. Do they rent the dozer by the day or is every 8 hrs a day. 40/8= 5 days x 300 = 1500 + fuel and deliver=2000 3 days lost at work x 150 = 450 Grade at least 8" deep but 16" in some spots because you can not blue top = 600 tons x 10.50 (7.50 + 3)= 6300 So now you are at $8750 That is a savings of $4250 so I say go for it and have fun.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|