|
Tractor Talk Discussion Board |
Re: Previous accident photos
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on February 22, 2005 at 18:36:16 from (192.75.48.150):
In Reply to: Previous accident photos posted by dr.sportster on February 22, 2005 at 14:23:31:
You can see the one previous set of tracks into the back field higher and steeper up the slope from where the the tractor resting. No sign of the front wheels cutting in on that one track so that was the trip in and empty. Looks like she rolled on the 1st trip out with a bale. The bales came from the field behind the tractor accident. Those rear wheels were not set out to full width and extra cast ballast cannot be seen. The bale bottom was up about the height of the top of the front tires. Too high as the bale's center of gravity is higher than the rear axle. That loader hasn't changed height much or if it's moved it was only "down". The boom and hydraulics are still under pressure and holding the sheet metal off the ground. That big old wet bale likely went 1500lb+ when dry. Probably had the hydraulics about maxed out to lift it too. That little tractor weighs about 4900lb dry plus what ever the loader weighs. The loader weight is mostly above the tractor centerline however. Even when ballasted with fluid that tractor likely wasn't over 6500lbs tops. Who knows what gear the driver was hurrying up to the the hay shed in. The ground doesn't look very smooth either. Bounce and roll.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|