Tractor Talk Discussion Board |
Re: PHOTO - Cenarth village store
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on June 21, 2007 at 10:31:59 from (64.12.116.14):
In Reply to: PHOTO - Cenarth village store posted by David in Wales on June 21, 2007 at 07:50:43:
One must have an appreciation for those old stone masonry buildings, kind of a lost art/trade today. I remember the concrete plank erector who was setting the precast concrete plank floors on a masonry high rise building I did in Manhattan, ( he was from your country, not sure where ) and he always mentioned in that unmistakable accent, that the masons/bricklayers were so sloppy over here, particularly on this job. Well even more so, the outfit hired for this job by the owners consultant and for me to deal with was less than desirable as far as the workmanship went, but he, Terry Wingrove, from Car-Win had mentioned that they were much more meticulous when setting the courses of brick, and that when topped off, there was no need for the washdown to the bottom as is common over here, cleaning up excess mortar and the face of brick etc. I had always wondered how masonry was done differently in your neck of the woods, having an appreciation for good and neat workmanship, sounded better than what is typical here, which can actually be very sloppy, depending on who is doing the work. That is a nice old building still in good use. My grandmothers place had an old country store and post office attached, kind of a neat old building and served a purpose, very convienent, even then, almost non-existent today though, I'd much rather support the small local places instead of the big box places
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|