|
Tractor Talk Discussion Board |
Re: Wisconsin 4 cylinder
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on February 05, 2005 at 08:29:17 from (66.163.134.177):
In Reply to: Re: Wisconsin 4 cylinder posted by cdmn on February 04, 2005 at 19:51:42:
Your brother the mechanic must have never had to keep one of the @%^& things running, or get it to re-start when warm! You are the first person I have EVER heard with anything GOOD to say about them! We had a number of them over the years, and it was ALWAYS something... stuck valves, blown head gaskets, oil burning. We had 2 old IH 163 swathers, one Wisconsin powered, and the other powered by an IH watercooled power unit. The Wisconsin was rebuilt numerous times, the IH watercooled NEVER needed any repairs, and when we junked the swathers, we put the IH engine in an "A" that had a cracked block, and mowed with it for YEARS more. After that, we had a 175 IH swather powered by a bigger VG4D engine. Same sorry piece of crap. After having it professionally rebuilt (by a Wisconsin distributor)($$$$$$), it ran ONE season before it started burning oil again. I replaced it with an industrial Chevy II 153 engine from an Owatonna swather, that already had seen a LOT of use. The Chevy had WAY MORE power and used less gas. I run that swather for YEARS with NO engine trouble, and still have it tucked away in the back of the quonset.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|