Tractor Talk Discussion Board |
Re: quick question on a big investment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JK-NY on February 02, 2005 at 16:54:31 from (69.67.227.97):
In Reply to: quick question on a big investment posted by old fashioned farmer on February 02, 2005 at 09:52:58:
Here's a couple idaes for you- 1)ck in the classified section of this site, there are a couple people here in NY who advertise alot of JD parts,you could email and see if they have any rims, if not maybe they could tell you where else to look. 2) ck on other JD tractor websites, even put a "wanted to buy" ad on and give iot a little time 3) post question with size needed to see if some other rims might work. Good luck on the parts hunt and job hunt, not sure of your situation but maybe you could still go back to school p/t for whatever you didnt take before that you need to get a job??Hope this helps JK
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|