Tractor Talk Discussion Board |
Re: OT: Setting a good example
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mydeere on February 01, 2005 at 09:55:00 from (63.148.249.11):
In Reply to: OT: Setting a good example posted by Mydeere on January 29, 2005 at 18:40:27:
I think a few of you misunderstood my post. First of all as a tax payer I don"t want Uncle Sam spending anymore of my hard and not easy to come by dollars then necessary to accopmlish whatever it is thier after. And belive me I fully understand we are in a global economy. Second, the point I"m trying to make is that when Uncle Sam decides to put something out to bid there are specifications that must be met. In all my dealings with Govt. projects they have enforced the fact that materials must be of US origin without any consideration of cost. Now like I said before they won"t let me use Canandian steel or hardware even if it will save us tax payers money. They go to the trouble and expense of hiring inspectors to make sure that the materials are American. Beleive me they will reject it if its not. Not having seen the request for proposal, I don"t know if the bidders were allowed to use foreign materials and labor. But based upon my experience, if one bidder proposes 100% domestic material and labor over a mixed domestic/foreign product, the proposal for the mixed source product is usually not awarded the contract because the item is offered by someone else as 100% domestic. Other than us footing the bill, I guess it doesn"t matter much as probably none of us will ever be going for a ride in it. Thanks for the exchange of ideas.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|