|
Tractor Talk Discussion Board |
Re: Misfiring @ idle John Deere A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DRL on January 27, 2005 at 17:03:26 from (207.254.224.166):
In Reply to: Misfiring @ idle John Deere A posted by Roy Miller on January 27, 2005 at 13:05:01:
Roy, This is the nature of the beast. With the single barrel carb and the firing order, all of those letter series two cylinders will miss, especially on the right hand cylinder. The John Deere two cylinder engine has a unique firing sequence. The #1 (left) cylinder fires, then at 180 degrees afterward, the #2 (right) cylinder fires. Then there is one and one half (540 degrees) revolutions of the crankshaft when neither fires. Then the sequence starts again. The left hand cylinder gets a fuller, richer charge of fuel vapor from the long 540 degree cycle whereas the right hand only has the 180 degree cycle to get it's charge. It will miss and pop at idle, (hence the nickname "Johnny Popper"), but put under load, both cylinders fire equally since the governor has opened the carb plus more vacuum pulling the fuel mixture through the carb and manifold. If you pull the plug wire off of the lefthand cylinder, the right hand cylinder will then start firing. Try it. If this doesn't help, post back and we'll go from there.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|