Re: Fabricate snow plow for tractor loader

Posted by RWK in WI on January 23, 2005 at 09:21:01 from (169.207.92.190):

In Reply to: Fabricate snow plow for tractor loader posted by bigblue on January 22, 2005 at 09:04:40:

One way is to mount a plate with two angle
iron brackets with hole to take a pin through
the rear hole on the plow A frame. By
mounting the plate with bolts it can be
removed in the summer. With this setup the
blade can be easily removed and the bucket is
available for regular use. The lift chain can be
hooked to the top of the bucket . Blade
angeling takes a set of hoses and a valve.
I have seen several set up this way. It does
make a longer rig for plowing.
The blade can also be attached directly to the
loader arms by removing the bucket and
makeing a mount to fit.
I hope this helps you.

Follow Ups:

• Re: Fabricate snow plow for tractor loader bigblue 20:06:33 01/23/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]