|
Tractor Talk Discussion Board |
Dam that sucks OR Boys! where's my stubby wrench
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on January 22, 2005 at 14:19:35 from (155.14.26.23):
Was working with my MF 50C TLB today trying to slope my driveway. Been a wet yr. Trying to improve runoff and prevent having a 4x4 driveway again this yr. Working along just fine and seen some sparks out the front end. Hmmm? Stopped the rig and went up front to investigate - found battery hold down rusted in half and broke. Got me some bungee cords and strapped it back down. Figured while in there I would retighten battery cables. Now where is that stubby 1/2" wrench I use? Dern boys must have run off with it, I sure can't find it. Oh well, get the only handy 1/2" laying around it is about 6" long. Cranking down the battery cables and KA-BLAM!!
Blew the top out of my big battery! Dam, there goes $$ down the drain. Luckily I just got acid on my hands and shirt. Must have grounded the + cable side to the frame with that long wrench. I guess tomorrow I will rob battery from another rig and try to get the job done. Just sharing :)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
