Tractor Talk Discussion Board |
Re: Metal Plating
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dr.sportster on January 10, 2005 at 10:26:27 from (209.247.222.116):
In Reply to: Metal Plating posted by Jeff Wenner on January 10, 2005 at 09:25:12:
Jeff,HERESone place;Advanced plating and powder coating,1425 Cowan Ct. Nashville ,Tenn.To give an idea;Sent them 61pcs mostly small[largest was Harley air cleaner cover.All show chrome except cocacola bottle opener TOTAl bill;$950 bootle opener[wall mount type ]was $45 for that peice.I kinda thought the prices real high and will look more locally next time.THE bottle opener was nickle plate and polish only not chro.Workmanship was outstanding.2 small pcs. were lost.FRee catologs 1800-5886686 free estimate.Im complaining but I used them twice once I shipped to them I thought high priced but they already have the parts in house from the estimate.Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|