Re: How to make a device to crank a tractor

Posted by Richard Fazio on December 31, 2004 at 05:22:27 from (68.161.215.25):

In Reply to: How to make a device to crank a tractor posted by James Herrman on December 29, 2004 at 21:40:03:

I made an electric starter for a hand crank welder I have. I just made a rod that I stuck in an old 1/2" electric drill. I put it in just like the crank. The drill has a threaded hole for a pipe handle. I put a piece of pipe down to an angle on the welder to keep the drill from turning. Then I pulled the trigger. She turns over fine. The drill is 400 RPM. You need a slow turning drill. The engine I was starting was 134 CID I think. I don't know how big the F-20 is. If it's too big that would make it harder to turn of course.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]