Tractor Talk Discussion Board |
Re: Funniest Tractor Memory
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene Davis (GA) on December 29, 2004 at 20:08:29 from (66.82.9.15):
In Reply to: Funniest Tractor Memory posted by Glenn F. on December 28, 2004 at 18:57:43:
When I was a boy,my father ran a JD dealership shop. I had always heard farmers talk about taking their foot and nudging the flywheel of an "H" john Deere to crank it when they were ready to start itback after they shut it down for lunch. Didn't believe it so I climbed on the "H" my father had just been working on. Of course I didn't look to see if it was out of gear or anything else that was safety concerned. That stuff was for other folks!! I took my left foot and just kicked the flywheel, and lo it did crank up aand was in gear! All I could think to do was to holler WHOA!! Luckily my father had stepped away from it and as slow as an "H" runs in 1st gear he was able to grab the clutch lever and stop it. I didn't sit down for a while after that paddling and didn't dare try that again!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|