|
Tractor Talk Discussion Board |
Re: OT - Oil Stove
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on December 18, 2004 at 11:16:42 from (66.163.134.177):
In Reply to: OT - Oil Stove posted by TDK on December 18, 2004 at 08:42:27:
The "carburetor" is more properly called a constant-level device. (A carburetor mixes fuel and air.) The float and needle valve maintain the oil level at a set height so there is a constant flow of oil through the regulating valve to the burner "pot". The second float is an emergency "trip" that shuts off the oil if the other float and needle valve are unable to regulate it to a safe level. There are adjusting screws that set the limits for high fire and low fire to a certain specified number of drops per minute, so that the stove will stay lit when the control is set on "low", and not overfuel when the control is set on "high". The owner's manual or a nameplate on the furnace may give these "spec's". Often, the pipe on the furnace into the "pot" will get clogged with crudded-up oil, and stop oil flow into the "pot". Usually, a plug may be removed from a "tee", and a wire run in to clean out the pipe. Also, usually there is a removable screen behind a plug, usually low down on the unit that may need cleaning. Post back if you have specific question beynd what I've posted. (BE CAREFULL, and don't try to relite a hot "pot" that's gone out, or use anything other than the recommended stove oil, or you may get your face burned off!)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
