Tractor Talk Discussion Board |
Re: 12-volt implements on 6-volt system
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on December 14, 2004 at 09:11:18 from (199.46.199.232):
In Reply to: 12-volt implements on 6-volt system posted by Tim B on December 14, 2004 at 08:56:55:
Couple of numbers for you. Depending on the way your winch is wound (series, parallel, series parallel) it may work your winch.......but. A winch is a work device. Work means HP. HP means Watts. At 6 V, watts means lotta amps. Let's say I have a 2 hp winch and use it to it's 2 hp capacity. I realize the way you are tuggin on your load helps determine how fast it will move a given distance for a given hp but: 2 hp @741 watts/hp = 1482 watts (forget losses for the calc. Would just make it worse.) So dividing watts by voltage, we get 1482/6 = 247 amperes. Now to start your n you only need 100 amperes or so. So you are asking of your electrical system bout 2.5 times what you ask of it to crank your engine (couple of seconds to do that) and ask for it for as long as you are winching the load. Get the Fire Truck something is gonna be on fire!!! Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|