Tractor Talk Discussion Board |
Re: ford truck- radius arm bushing???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.Evil on December 09, 2004 at 09:41:27 from (216.136.115.250):
In Reply to: Re: ford truck- radius arm bushing??? posted by Redmud on December 08, 2004 at 16:47:38:
It's in My HELMS official FORD Service Manuals (same one's My dealership has) that bolts are approved for replacing rivets in the frames. Directions get fairly detailed about grade, length, and size of bolts, types of washers, etc.... On Son's truck the rivets must have been 12mm. 7/16" bolts were sloppy, 1/2" wouldn't fit... so We bored each hole out as We ground the heads flush & punched the rivets out one-at-a-time so the bracket maintains alignment. Truck is a '93 F-150 LIGHTNING..... They're REAL hard on those bushings....
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|