|
Tractor Talk Discussion Board |
Re: Massey Harris Serial Numer locations
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on December 09, 2004 at 05:43:20 from (64.42.242.43):
In Reply to: Massey Harris Serial Numer locations posted by Schultzy on December 08, 2004 at 20:13:50:
Not totally sure about a 555 but on all other earlier Masseys, it was hand-stamped into the upper machined surface of the transmission case between the cast iron shifting platform (supports shift lever) and the steel plate covering the differential gears. It's there on the left side near the location where the clutch pedal is when it's fully in the out position. The numbers are big but sometimes not too deep so you'll have to wire brush the area. As I said, I'm not totally sure about the triple-numbered Masseys. There are casting dates on the bottom of the Transmission/differential housing, those will give you a date when that casting was poured, probably pretty close to the tractor model year but not necessarily spot on.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|