Tractor Talk Discussion Board |
Re: Farmall 400 resistor smoking
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on December 08, 2004 at 19:29:17 from (66.163.134.177):
In Reply to: Farmall 400 resistor smoking posted by Hairry on December 08, 2004 at 18:37:56:
I assume you're talking about the ignition ballast resistor, and the way I understand you, the resistor is getting hot without the engine running. If that is true, the voltage regulator would have nothing to do with it, without the engine running. Anytime the ignition switch is "ON", and the engine is stopped at a point where the breaker points are CLOSED, the ballast resistor will begin to heat up. If the engine is rotated just enough for the points to open, there should be no current through the ignition system, and the resistor should cool down. If it remains hot even with the points open, you have a short in the wire to the coil, the coil itself, the wire from the coil to the distributor, the condensor, or the points themselves.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|