|
Tractor Talk Discussion Board |
Re: Chrysler 2.7 V6
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by caseyc on December 02, 2004 at 06:33:42 from (66.17.100.10):
In Reply to: Chrysler 2.7 V6 posted by dhermesc on December 01, 2004 at 09:48:28:
i've worked for dodge for 4 years now and my dealer has thousands of those motors on the raod over the years. we've only ever replaced one engine and that was because the quick lube place forgot the part where you put the drain plug back in after the oil is done draining! several mechanics own cars with the 2.7 and love them to death. i'm not saying they are perfect, dodge does know they have a sludging problem. if you keep the oil changed every 2500-3000 miles and use quality products you will be ok. since you said it was a 2004 you should also have the 7yr/70,000 mile warrenty also so don't worry....your covered!!! good luck and enjoy your dodge product. casey
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|