Tractor Talk Discussion Board |
Re: IH 300 width
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on December 01, 2004 at 14:32:04 from (64.228.11.185):
In Reply to: Re: IH 300 width posted by paul on December 01, 2004 at 12:09:18:
paul: I had a Farmall 300 axle twist about 1/5 turn, and not break. Wheel was dished in and out on end of axle. I ran the tractor for about 6 months that way and replaced axle. I then dished wheels out. Dealer was suposed to do that before delivery. Dad had said he wanted 72" centers and with double bead rims you could achive that with wheels dished in. I broke two axles on a 100 hp Deere, with ROPS cab, but even with that it was a rough ride both times. It was a forestry skidder articulated, same rear ends as 4020 but with a flange axle. Rear axles on those took a beating as logging arch would pickup 5 ton.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|