Tractor Talk Discussion Board |
Re: Best way to break in a rebiult motor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by johndeereman on November 28, 2004 at 09:41:24 from (66.133.185.111):
In Reply to: Best way to break in a rebiult motor posted by Bill from Seneca, IL on November 27, 2004 at 18:06:38:
as u can see there is more ways to do it than u can shake a stick at the way we always did it was to break it in the way you were gonna use it you dont want to break it in at a light load if you are gonna work it hard all its life after all you wouldnt expect a 400 lb man to win the olimpics in the 100 meter dash would you? if you break it in lazily thats the way its gonna work or it will blow up just like the 400 lb mans heart would. i worked at a jd garage we would putz it on a dino for a half hour at 2/3 throttle then change oil and take it home with orders not to take it easy on it after 30+ years they have never had an engine job come back i think all these guys ideas will work some take longer than others the key is just dont let it idle itself in
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|