Re: WIRING BRAKE CONTROLER PICTURE..

Posted by Ray,IN on November 27, 2004 at 19:56:48 from (66.244.71.39):

In Reply to: Re: WIRING BRAKE CONTROLER PICTURE.. posted by daniel gillespie on November 27, 2004 at 19:03:06:

The spring resistor was used on the hyd over electric controllers, and worked very well. The brake wire feeding the electric trailer brakes passes through the spring resistor. It may be adjusted to supply either 1,2,3 or 4 axle brakes. It is not needed with the newer all electric type electric brake controllers. If you have a hydraulic line from your master cylinder to the controller you need the spring resistor. If you have to adjust the spring resistor clamp all the way towards the terminals, you likely have a problem in the brake wiring on the trailer.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]