|
Tractor Talk Discussion Board |
Re: Best way to break in a rebiult motor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RN on November 27, 2004 at 18:41:22 from (166.126.218.219):
In Reply to: Best way to break in a rebiult motor posted by Bill from Seneca, IL on November 27, 2004 at 18:06:38:
Breakin rebuilt? Lots of ways, here is opinion for your Cub this time of year- 10W valvoline racing oil in engine, 1 cup 30w non detergent low ash oil to 5 gallons gas for start. 1st 2/5 hours running don't get over 2/3 throttle. vary speed up/down while under light load- wagon pulling or something like light cultivating garden. Next 5 hours can go to full trottle medium load. Garden plow/cultivate/mow in low gear short rows - vary engine speed end rows and turns. Drain oil at about 10 Hours, switch to 10w30 weight, change filter, reduce oil in gas to 1 cup to 10 gallons. Go next 25 hours up to near full throttle and medium loads while varying engine speed occasionaly- slow to idle on corners, end rows, whatever/whenever you feel like it. Drain oil at 20-25 hours and run 10w30 for winter, 15/40 or straight 30 for summer. Try to change oil at least twice a year or 100 hours afterwards, no more oil in gas needed. Rings should seat in 1st 5-10 hours, valves should work lap themselves to seats and guides and bearings fit themselves to journals at same 5-10 hours. Second 5 hours under some load should have engine at full operation temp. At 1st oil change 10 hours, check head bolt torque/retorque to specs, check intake/exhaust bolts also, check valve lash clearance. RN.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|