Tractor Talk Discussion Board |
Re: walk behind tractor with one and a half horse
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RN on November 27, 2004 at 17:37:52 from (166.126.218.219):
In Reply to: walk behind tractor with one and a half horse clin posted by Thomas King on November 27, 2004 at 10:41:15:
Clinton engine? Clinton plant in Iowa shutdown 1999, had been making some replacement parts since 1970s. Quick search brought up rings and gaskets available, Ebay had various old engines, manuals, parts. Note on engine HP rating-1.5 horse may be at 1800 RPM, compareable to about 4 hp at 3600 rpm new engines. Tecumseh 5hp replacement engine used to have governor small parts kit for 1600-1800 rpm use -generator and water pump replacement for 1950s spec engines. Keep engine speed specs in mind if you replace engine with new other than Clinton engine. RN.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|