Re: What makes a Bobcat 743b Creep?

Posted by Shep VA on November 23, 2004 at 11:03:02 from (68.152.9.254):

In Reply to: What makes a Bobcat 743b Creep? posted by Kraig Kutcher on November 23, 2004 at 09:34:02:

Yes and no. Sometimes you can adjust the tension on the springs that hold the levers in center if the levers are causing the creep. Under the cab you will find where the levers move back and forth and there are two spings in there I think. If you tighten up the springs the lever will get harder to move and "should help to keep the pressure off the drive.

If it is creeping from the valve unit there is not much you can do about that. Normally if you have a low houred machine the levers are the problem, higher houred machines tend to have more valve problems.

As they get older and more hours there is just no real good way to stop it from creeping.

Good luck

Follow Ups:

• Re: What makes a Bobcat 743b Creep? Jim861 10:09:15 11/27/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]