|
Tractor Talk Discussion Board |
Re: ot anybody have this a truck?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Britt on November 16, 2004 at 15:56:06 from (207.69.137.135):
In Reply to: ot anybody have this a truck? posted by haulnredneck on November 16, 2004 at 13:25:17:
I drove a company owned 1988 F250 extended cab with a manual 5 speed and a 7.3 non turbo. You have to understand that I am a Chevy man, but that 88 Ford was a great truck. It would get over 20 MPG on a trip and the performance was not bad at all for a diesel. It wouldn"t beat a similar truck with a 460 or 454, but then you didn"t need to own an oil well to keep it in fuel either. As far as towing, I towed a 32 foot job trailer between Guthrie and Dickens Texas. That was a bit much for the old girl. But the job trailer was not at all streamlined. It was 8" wide and 12" high. Talk about wind resistance!! If you live in flat country, then I don"t think that you would go wrong. But if you are thinking of hauling more than 6/8000 lbs. with it, or in hilly terrain, I would think seriously about a 2 ton or bigger rig. Make SURE that your trailer brakes work on WHATEVER you haul. Even a small tractor can push you right through an intersection if you don"t have trailer brakes. I have seen quite a few wrecks where either the trailer didn"t have any brakes, or they weren"t hooked up. Johnny Law & your insurance company take a dim view of inadequate brakes. The 88 F250 that I had was a great driving truck. With the long wheelbase because of the extended cab and the 8 foot bed, it rode exceptionally well for a 3/4 ton truck. Good Luck, Britt
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|